Installing a House

These are the instructions for all of our rez-faux packaged houses.

Put your Synz Creations package on the ground and rez the house by touching the package and then selecting “rez” on the offered menu.

In order to postition the house, you have to “Edit” the Synz Creations package it was rezzed from. After rezzing, this will usually actually be inside the house! Then, whatever you do to the Synz Creations package will be mirrored in the house itself, so if you rotate it, the house rotates. If you move it, the house moves and so on.

I suggest you get your rotation correct first. After ‘edit’ you need to select ‘Rotate’.

You rotate the house by using the mouse to drag around the blue ring now around the Synz Creations package. A garden looks great facing the sunset!

Then when the orientation is correct, you are ready to position your house.

Edit the house again, check its on ‘move’ this time, and find the Position section of the ‘Object’ tab (the bit with the coloured x, y, z followed by numbers).

The “Object” tab lists the x, y, z coordinates for the whole house. The position on the land is given by the red x and green y.  The blue z is the value for the height. You can type new values into this boxes or you can just use the correctly coloured arrows.

At this point, the position of the house should be saved. This is achieved by touching the Synz Creation package again to get the rez-fauz menu up, and then selecting ‘Save’.

Once the house is in the required position, I strongly advise you to “lock” the house. This option can be found on the “edit” menu again. This means that when adding plants, furniture or other building tasks on the skybox, you can’t accidently move, change or even delete your house.

Then you just need to move in!

Advertisements
Published on May 10, 2011 at 12:00 am  Comments Off on Installing a House  
%d bloggers like this: